12 string on CTLs 1&2

Started by Tiltfinger, February 02, 2024, 02:23:43 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Tiltfinger

I'm new here and to SY1000. Maybe this has been addressed previously.

When selecting the 1:12STR function on CTL1&2, I get an loud, unusable crackling noise from the low E to the D strings when anything touches them (finger, pick, etc.) even with the slightest pressure. The B & E sound ok.
I've tried turning any other effect and/or emulator off within the patch to isolate with no success.

Also, the other 12 string selections (2:12STR, 3:STR, & ALL:12STR) don't create any sound at all.

Any ideas on how to solve this?

Any help is much appreciated.

Gtr: Emerald Virtuo

Brak(E)man

(Try another cable.)
Backup patches
Do a factory reset
Install latest firmware
swimming with a hole in my body

I play Country music too, I'm just not sure which country it's from...

"The only thing worse than a guitar is a guitarist!"
- Lydia Lunch

stub

There's the sensitivity settings in the GK settings. But yea, sounds like it could be a cable issue, or something just went wonky. Brak(E)man's suggestions are a good start.

Tiltfinger

I'll try that.
Thanks very much.

Brent Flash

Welcome to the group  Tiltfinger!  :)

Tiltfinger

Much appreciated, Brent!