Author Topic: USB Class Compliant - USBAudio2.0 mode" support "driverless" 24 bit audio  (Read 1346 times)

0 Members and 1 Guest are viewing this topic.

Offline Elantric

All the following products support "driverless" 24 bit audio I/O using USB Class Compliant Mode or "USB Audio 2.0 mode".

This is important if you want to use these interfaces with iPad/ iPhone/ Android / Linux

Apogee JAM
IK Multimedia iRig HD
IK Multimedia iRig Pro

Peavey AmpKit Link HD

Roland UA-22 Duo Capture EX
Roland FA-6, FA-8

Steinberg UR Series

Focusrite Scarlett 2i2
Focusrite Scarlett 2i4
Focusrite Scarlett 18i6
Focusrite Scarlett 18i20

Presonus AudioBox 1818VSL

Digitech GNX3000

Digitech GSP-1101

Lexicon Omega Studio

Vox VXII Amp

Korg PX5D

more here too

Further reading about 24 bit USB Class Compliant Audio - which is the current standard for interfacing with iPads and Android Tablets

USB Device Classification for Audio Devices

unzip - find the doc named "Audio20_final.pdf
« Last Edit: August 07, 2015, 11:46:58 AM by Elantric »

Offline Elantric

« Last Edit: August 07, 2015, 11:35:04 AM by Elantric »

Offline Elantric

These Roland Audio Interfaces are USB Class Compliant

Roland FA-06, FA-08

Tags: FA-06, FA-08, USB, Driver
The FA-06 and FA-08 allow you to change the USB Driver setting - the available options are:

VENDER: This setting requires that you install a Roland USB driver on your computer for the FA-06 or FA-08, and allows you to transfer both MIDI and Audio through the USB connection. This is the 'normal' setting used when connecting to a computer.
GENERIC: This setting does not require a Roland USB driver to be installed (it instead uses the built-in driver in your computer's operating system), and is also referred to as "Class Compliant." This is a good option when a USB driver is not available for your computer, or when you are connecting to an iOS device.
Here are the steps to change the USB Driver setting on the FA-06/08:

Press MENU.
Cursor to "System" and press ENTER.
Use the </> buttons to select the "General" tab at the top of the screen.
Cursor to "USB Driver" and use the Value Dial to set this to "VENDER (MIDI+AUDIO)" or "GENERIC (MIDI ONLY)." You will need to press the #6 button under the screen (which has "WRITE" displayed above it on the screen) to proceed.
Power off then back on the FA-06/08.

Offline admsustainiac

« Last Edit: August 09, 2015, 11:04:12 AM by admsustainiac »