605AF362-6CB9-4D50-BA99-0305B36AB96B.jpeg JBW CORE +9 dB.tsl This liveset is for a GT-1000CORE into my guitar amp input. It is set up for two FS-7 switches (or any other two-button switches). The presets range from clean to moderate gain.
CTL4/5 do preset up/down, which frees up the three foot switches on the CORE for effects with the benefit of the LEDs.
Down Arrow - DIST2 block
Up Arrow - FX block
CTL1 - solo boost (usually DIST1 solo)
CTL2 - toggle between two FX types (when FX block (^ arrow) is on)
CTL3 - FX options (e.g., fast/slow modulation speed)
For manual mode:
DOWN - Master Delay
UP - Compressor
I don't use the amp or reverb blocks in the main output signal chain to my external amplifier input (I use the amp's reverb), but AMP/REV blocks are in the sub-out chain if I want to go direct to the PA/mixer. The external amp is a deluxe reverb type set to edge-of-breakup.
The first five presets are my bread & butter, progressing from really clean to moderate overdrive. Presets 6-10 are variations on medium gain and FX choices. For Jekyll & Hyde the down arrow switches between clean and a gnarly distortion mixed with ring modulation. Jekyll & Hymie is a tamer version.
I play a Tele style guitar with moderate output pickups and the volume rolled back to 7, so setting the GT1000 input to +9 dB works for me. Amazing how much the input setting affects the tone!
Updated with what I'm using now.
This liveset is for a GT-1000CORE into my guitar amp input. It is set up for two FS-7 switches (or any other two-button switches). The presets range from clean to moderate gain.
CTL4/5 do preset up/down, which frees the up/down arrow foot switches on the CORE for effects that benefit from the LEDs.
Down Arrow - Solo boost (usually DIST1 solo)
Up Arrow - Toggles EQ
CTL1 - DIST2 block
CTL2 - FX options (e.g., fast/slow modulation speed)
CTL3 - FX block toggle (Usually tremolo)
For manual mode:
DOWN - Master Delay
UP - Master Delay Tap
I don't use the amp or reverb blocks in the main output signal chain to my external amplifier input (I use the amp's reverb), but AMP/REV blocks are in the sub-out chain if I want to go direct to the PA/mixer. The external amp is a deluxe reverb type set to edge-of-breakup.