GT-100 - Swapping pre-amp for a solo?

Started by donlizard, July 01, 2015, 05:39:55 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

donlizard

July 01, 2015, 05:39:55 PM Last Edit: March 09, 2017, 04:50:41 PM by admsustainiac
Hi everyone,
I have a patch that has a vox amp for preamp 1 and a Marshall for preamp 2. During a song I want preamp 1 on, when it comes to the solo I want preamp 1 to turn off and preamp two to kick in with using the ctl pedal. I already have assigns turning delay on and chorus off when the ctl pedal is used, but I can't figure out the other part. Any help?
Thanks,
Don
Godin xTSA
GC1 - Strat
G&L F-100 with GK3
GT-100
GR-55
Roland/Edirol SD-80 Studio Sound Canvas
Roland KC-500 x2 (Running in stereo)
and waaaay too much other stuff.

Mrchevy

#1
July 01, 2015, 08:14:46 PM
On the pedal board, press the CTL/EXP button. Highlight ACCEL/CTL in the left window. In the right window, use the 1st knob (Func)to select DIV CH SELECT.  Knob 2 set MIN to CH-A .  Knob 3 set MAX to CH-B.  Knob 4 SOURCE MODE set to TOGGLE. See preset P13-1 PLEXI RHYTHM for an example. Have fun.
Gibson Les Paul Custom
Epi Les Paul Standard
Gibson SG 50's prototype
Squire classic vibe 60's
Epi LP Modern
Epi SG Custom
Martin acoustic

Princeton chorus 210

GT100
GR-55
Helix LT
Waza Air Headphones
Boomerang III

And, a lot of stuff I DON'T need

donlizard

#2
July 02, 2015, 05:53:40 PM
BAM!
Thank you so much Mrchevy!
That did the trick!
This changes everything, less patches to do the thing I want.

Thanks again,

Don
Godin xTSA
GC1 - Strat
G&L F-100 with GK3
GT-100
GR-55
Roland/Edirol SD-80 Studio Sound Canvas
Roland KC-500 x2 (Running in stereo)
and waaaay too much other stuff.
Print
Go Up Pages1
User actions