ATG-1 Inside View

Started by admin, November 21, 2017, 08:24:19 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

admin

aka as "the smugglers special"



Ok all sorted.

You need to remove the three black hex screws from the back and all the silver crosshead screws from the bottom plate and then the bottom plate lists off.



In the pic included there are two hex bolts marked with a red arrow, these are used to adjust the stiffness of the pedal.

I first started to try to get the pin out of the middle of the pedal by untightening the hex bolts and untightening the grub screws but it was pretty stuck. So it looked like the way forward was to remove the side of the unit and the sensor pcb and try to knock the pin out with a punch to grease it.

Instead I took the bodgers approach and masked off the sensor PCB and sprayed some WD-40 White Lithium Grease in the gaps under the hex bolts with the unit at 90 degrees to it would run down into the area around the central pin and wiggled the pedal around a bit before tightening the hex bolts again.

Seems to have sorted it, nice and smooth now.

Cheers

Andy

vtgearhead

All images show as "removed", FYI.

rolfay


admin

There were some duplicate pics with stale 4 year old links - recently removed

see 1st post for ATG-1 Inside View