Send sequence of MIDI commands to RC-300

Started by chrisa, May 18, 2023, 05:05:36 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

chrisa

Hello all. Frequent reader, first time poster. I know that it's possible to use MIDI messages from an external controller to control the RC-300 (stop/start loops on various channels etc.), but I wanted to know if it possible to import a whole series of commands (for example all of the stops/starts/overdubs for a particular song to avoid me needing to do any tap dancing)?

I'm assuming it's not possible to just load in a song onto the device and it would require an additional bit of hardware, just wondering if anyone here has already achieved this and has any recommendations of how to do it.