Axon ax100 connection problem

Started by NikosMargi, July 02, 2021, 03:31:57 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

NikosMargi

Hi everyone! I'm trying to connect my axon ax100 mkii to pc editor and it stucks without filling the bar to a window says "received MIDI mapping table from AXON please wait " and nothing happens ! After some difficulties i sussesfully update the firmware to v7.28 but the connection between axon and editor its kinda difficult. Any ideas ? Thank you in advance!

arkieboy

Axon units are notoriously picky about midi interfaces - IIRC there's a list of compatible interfaces in the manual.  You may have to try a couple.


I always communicated with mine using an Emagic AMT8 and had no issues - if you can pick one up from eBay (check for PC drivers!) they are incredibly useful as they will allow you to control your hardware synthesisers much better from your Axon.  The maudio units were fine too IIRC.
Main rig: Barden Hexacaster and Brian Moore i2.13 controllers
Boss SY1000/Boss GKC-AD/Boss GM-800/Laney LFR112

Other relevant gear: Line 6 Helix LT, Roland GR-33, Axon AX100 MkII
Oberheim Matrix 6R, Supernova IIR, EMu E5000, Apple Mainstage, Apple Logic, MOTU M4