RC300 - How to program my FS-6 pedal???

Started by csassakb1, April 14, 2014, 02:26:17 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

csassakb1

All

I bought an FS-6 pedal.  I want to program my RC 300 so I can use the two pedals on the FS-6 to move up and down among the banks I have saved.

Problem is, I can get it programmed to where the one pedal moves up in the banks, but can't figure out how to get it programmed to get the other pedal to move down in the banks. 

also, I have been connecting this to the ctl 1, 2,/exp 2 input....................my question is, when I go to the assigns, should I assign it to CTL 1 or CTL 2 or EXP 2? 

I'm a bit lost on this one

Curt

Cricket

#1
Does the other pedal not do anything at all? 

If not, make sure you are using a TRS cable.   If you are, try a different one.

If the cable is good, check your assigns, CTL 1 and CTL 2 go together, so if you assign bank up to CTL 1 and bank down to CTL 2 you should be good.  If you can program one, you can program the other.

Btw, there are no global settings; you have to make this assign setting in every patch you want it to work on.  So if you set it on patch 1 and bank up to patch 2, you won't be able to get back to patch 1 until you make these settings in patch 2 also... see?

Hope this helps.

csassakb1